Zenith Universal Remote Codes & Program Methods

Hello Users, programming a Zenith Universal Remote just takes a few steps but often the users find it difficult so here we have come up with the best methods for you to program your universal remote in quick and easy steps. Just follow any of the methods mentioned below and you are all ready to use your zenith remote.

  • Programming Zenith Universal Remote without Codes:

In this method the codes in the remote are put through a search by searching one code at a time until it finds the one that works with your remote.

STEPS TO FOLLOW:

  1. Turn on the device you want to program to use with the remote(ex: If you want to setup the remote for TV then switch on the TV manually)
  2. Switch On the remote and from the various device buttons on the remote (TV, DVD, CBL and OK/SEL) press and hold the one which matches with your device for around 3 seconds until the LED lights up indicating that the remote is ready to program.
  3. Point the remote towards the device and press “CH+” and “CH-“buttons until the device turns off.
  4. To check the code, press on the power button. Once the device is turned on, change channels to confirm that the remote is programmed perfectly.
  5. To save the code, press the device button. LED will light twice confirming the code stored.
  • Programming Zenith Universal Remote Manually:

This method is useful when you have located the code of the device. The code automatically recognizes the device and thus easily program the remote.

STEPS TO FOLLOW:

  1. Turn on the device you want to program to use with the remote(ex: If you want to setup the remote for TV then switch on the TV manually)
  2. Switch On the remote and from the various device buttons on the remote (TV, DVD, CBL and OK/SEL) press and hold the one which matches with your device for around 3 seconds until the LED lights up indicating that the remote is ready to program.
  3. Enter the remote code for the device (you will find it in the instruction manual of the remote) using the number buttons.
  4. Now press and hold the power button on the remote, while pointing it towards the device until the device turns off.

This is the simplest way to program your remote. In case the device is not operating then try some different code from the manual and repeat the above mentioned steps.

  • Programming Zenith Universal Remote with Code Search:

In case you do not have the code for the device, you can then go for this method to program your remote by putting it on search mode by the use of manual codes. The remote will then be searching for a code until it finds the correct one for your device.

STEPS TO FOLLOW:

  1. Turn on the device you want to program to use with the remote (ex: If you want to setup the remote for TV then switch on the TV manually)
  2. Press and hold the Setup button on the remote while entering three digit 9-9-1 code.
  3. Next press and hold the power button and the channel up button till the device turns off.
  4. The turn off indicates that the device is programmed.

This method may be time consuming compare to the other methods but once you are done with the above mentioned steps the universal remote will work properly.

 

Leave a Reply

Your email address will not be published. Required fields are marked *