If you are searching for the best pairing codes for programming your DVD player with the RCA remote, check the below list of codes.
You will surely get the key code here for setting up your device. Look into the table and find the matching code for your DVD from the list of RCA remote codes.
How to Program the RCA Universal Remote without applying Codes? (Auto-Search Method)
If you don’t have the list of codes with you, you can program the RCA remote manually. This auto- search technique is the simplest way to program your RCA remote. Follow the given steps in the step-by-step format:
Step-1 Initially, plug in the device that you wish to program with the RCA universal remote control.
Step-2 Next, press the ‘Setup’ button of the RCA remote and hold it down for a while. You will observe the red light blinking twice.
Step-3 After that, input the code (9-9-1). Again, the red light will flash two times to denote that you are in manual programming mode.
Step-4 Press and leave the component button for the device on the remote. For example, TV is for televisions, CBL is for Cable Boxes and DVD is for DVD Players, etc. The red light should flash one time.
Step-5 Aim the RCA universal remote at the device. Tap and hold down the ‘Power’ switch till the device goes off. If this is successful, the red light will flash twice again.
Step-6 Now, you are ready to use the RCA remote for operating your brand device without codes.
Universal Remote Program & code3 years ago
